Olympus. CH30: Reibung des Fokusantriebs

Begonnen von Krishan, August 30, 2020, 14:11:37 NACHMITTAGS

Vorheriges Thema - Nächstes Thema

Krishan

Hallo zusammen, ich habe ja ein gebrauchtes CH30 erworben, das bis auf ein Problem wirklich sehr gut intakt ist. Einziger Fehler ist der Fokussierantrieb, dieser hat so wenig Reibung, dass der Tisch durch sein Eigengewicht nach unten sinkt. Lässt sich das Problem selbst beheben?
Danke im voraus für Eure Tipps.
Olympus CH30 (Plan/Fotos), CH2 (PhaKo), SD30 (Stereo)

deBult

#1
http://www.alanwood.net/downloads/olympus-ch30-ch40-instructions.pdf page 13.

http://alanwood.net/downloads/olympus-ch3-ch30-ch40-cx40-repair-manual.pdf

But: common issue when the scope is send via the mail and not properly dismantled and packaged is a crack in the plastic gear in the fine/course focus gearbox.

Best, Maarten

Note did you receive my mail on the Phase objectives?
Reading the German language is OK for me, writing is a different matter though: my apologies.

A few Olympus BH2 and CH2 stands with DIC and phase optics.
The correct number of scopes to own is N+1 (Where N is the number currently owned).

Krishan

Okay, manchmal hilft ein Blick in die Anleitung. Ließ sich mit dem entsprechenden Ring hinter dem rechten Grobtrieb problemlos korrigieren. Den habe ich auch am CH-2, habe ihn aber noch nie benötigt. Jetzt ist alles fein.
Olympus CH30 (Plan/Fotos), CH2 (PhaKo), SD30 (Stereo)